Ik zit sinds vandaag met een onverwachts WIFI probleem die niet meer wilt werken.
Ik heb nog niet echt een eenvoudige oplossing kunnen vinden. Ik baal daar best van gezien de garantie al verlopen is. Mijn vraag is of jullie nog tips hebben?
Ik heb uiteraard het een en ander zelf geprobeerd maar tot op heden zonder succes.
Via WIFI instellingen blijft deze op OFF staan en druk ik op On dan gaat de WIFI zonder verbinding te maken na 3 seconden weer op OFF. Opnieuw andere firmware's of kernels installeren heeft het probleem ook niet opgelost.
Via internet ben ik verder op onderzoek uitgegaan en kwam ik het volgende tegen wat overeen komt met de klachten die ik met de SG2 op dit moment ondervind.
Daar wordt ook besproken wat de oorzaak zou kunnen zijn.
But after reading the article you mentioned the BAT 500 acid leak issue seems to be a pretty valid and more probable situation in the case of OP, the situation has been confirmed by several people and there are people who actually just opened up the device and started to see the circuit leak, and the best recommended situation is to remove it, also the problem can be fixed without replacing the motherboard by an expert in electronics, as usually wifi gets damaged when the BAT500 leak gets to the resistors related to the wifi IC, or the IC itself, some people even reported cleaning the leak off with alcohol and removing BAT500 also fixes it, also for anyone interested BAT500 looks like a internal CMOS battery but it's used as a capacitor actually, so it's not quite necessary, but you will have issues like internal component life reduced.. Bla Bla Bla.... (Read up on uses of capacitors)....
P.S I mentioned an expert in electronics because some people who actually fixed them had to work under a 20x zoom microscope to fix this. For some it was easy as just removing the BAT500 component and replacing the(usually fried) resistors(there are 5 related to the wifi IC and only the burnt out resistors need to be changed), and for some even easier still like removing and cleaning.
Bron:
XDA
Het probleem zou hem dan zitten in de extra kleine
leaky battery BAT500 batterij waardoor de WIFI chip door de lekkende batterij beschadigd kan raken. Op XDA is daar meer
klachten over te lezen.
Nu heb ik ook op het forum gelezen dat mocht de schade mee vallen het mogelijk moet zijn de SG2 open te maken en de contact punten op het moederbord zelf schoon te maken. Ik zou dit kunnen doen maar ik vraag me af of dit geen fabricage fout is of wellicht toch een ander probleem?