Ik heb de Pipo max M9 vandaag binnen gekregen (is gisteren opgestuurd vanuit HK, speed delivery werkt echt binnen 1 dag

).
Ik probeer 'm nu te flashen, ik wil
deze rom erop zetten. (Ik heb ook de iso van Hejira maar omdat die specifiek GB editie in de naam heeft, opteer ik voor de wat oudere gecleande rom.
Ik volg het volgende stappenplan (zet 'm even hier neer, want ik weet niet of iedereen een account by flashmyandroid heeft)
1. Requirements:
1.Rockchip Batch Tool v1.6 (DOWNLOAD)
2.Stock or Custom Firmware
3.Windows PC
4.USB Cable
2. Initial setup
1.Extract the Batch Tool (RBT in the following) package. It includes the needed drivers too!
2.Extract the downloaded firmware image
3.Run RBT, and browse the image file in
4.If everything done right, you should see some info printed in the fields, like the current version of the firmware, Android, the board (RK30), etc
3. Installing device drivers
1.Press back key for a few seconds and then press reset at same time.
2.As Windows notices the new device, release the back button.
3.When asked for drivers, browse to the extracted RBT directory, select the directory "Drivers", and let Windows install the matching ones
4.When finished, you should see one of the fields in RBT turngreen from grey
4. Installing the new firmware
1.After plugging in the tablet, and the green field pops up on the bottom, press the "Upgrade" button
2.You should see the text Download firmware start.
3.If everything done right, you should see a message like this:
4.**********Upgrade Done Success<1> Fail<0> Timems**********
5.If it finished without a problem, the tablet should boot up immediately. If not, just press the power button, and wait until it boots.
Het gaat helemaal goed tot stap 3.1 / 3.2; met de back key bedoelen ze de esc neem ik aan? ALs ik het stappenplan volg, dus de esc key inhoud, op reset druk en ondertussen reset vasthoud, gebeurt er helemaal niets. Het tablet gooit zichzelf uit en blijft lekker uit staan. Windows geeft niet aan dat tie nieuwe hardware vindt. Wat doe ik fout?