Precies zo gedaan als hieronder staat? Overigens wil het nog wel eens helpen om het tablet helemaal uit te zetten en dan weer opstarten om van die melding van de Rriley flashtool melding af te komen.
Open the main folder and run the flash tool as administrator.
Make sure USB debugging is turned off.
Unmount and remove your external SD card.
Plug in your USB cable to your PC and to the tablet. I have found that you have better luck using the USB cable provided with your tablet. It has a longer connection on the micro USB end which is required to fit the tablet and make a good connection (don't loose this cable, because it may be the only cable that will work with your tablet).
If you have the driver already installed...after a few seconds, the flash tool will recognize your tablet as a "Mass Storage Device". Give it a few seconds and then click the "Reboot2Flash" button at the bottom of the Flash Tool window. You should get a confirmation box that it worked "Flash Mode Success", and the notification area will change to "Found RKAndroid Loader Rock Usb"
Wait a few seconds and then click the "EraseIDB" button. It should count up to 16384. If it doesn't count all the way to 16384, you don't have a proper connection...so start over by rebooting to system. You will get a confirmation box that says Erasing IDB OK. Click OK.
Now, click "Flash ROM". The ROM tool will write the ROM to your tablet and then check the installation. Just let it run until you see the RileyROM badge screen.
Once you flash the ROM it will immediately boot into CWM Recovery by Fun. You get error messages at the bottom saying Invalid Command Arguement...etc...so just ignore that.
By swipeing the screen up and down, move through the CWM menu and select "wipe cache partition" and press the power button. Swipe down to confirm "Yes - Wipe Cache" and press the power button.
The main screen shows up again. Just press the power button and boot the system.
[
Voor 4% gewijzigd door
starcopy op 24-08-2013 14:36
]