als je bijvoorbeeld een REL quake subwoofer gebruikt, die kan je op 2 manieren aansluiten. 1 kabel voor de LFE poort (de .1) en een andere voor de aanvulling op je large speakers (fronts dus). hieronder een quote van de website van REL
edit:
wat je dus niet kan is je rears en center tonen laten weergeven onder de 100hz tenzij ze op large staan (marantz kan je instelen op 80-100-120hz meen ik, yamaha weet ik niet)
verder kan je op de subwoofer ook een crossover frequentie instellen wanneer deze moet invallen naast je fronts. je versterker regelt dus met large/small@100hz dat alle small speakers hun geluid onder de 100hz op de fronts afspelen. de sub kan je dan instellen dat hij bijvoorbeeld onder de 60hz de tonen OOK moet weergeven naast de fronts (meestal klinkt de bas van de sub beter dan die van een normale speaker)The REL system will, uniquely, allow you to adjust both high and low level inputs individually and connect them simultaneously. For Dolby Digital AC-3® or other multi-channel movie or music systems, connect the left and right amplifier outputs (as in a standard two channel system) to the ABC™ high level input using the high level cable. For this configuration, you must set the processor to the “large” or “full range” setting for the left and right speakers in order for the REL to receive the bass signal. In addition to the high-level cable coming from the amplifier, run a low-level phono cable from the .1 LFE output of the processor. It is important to provide low frequency support to the full range left and right channel speakers, in addition to pressurizing the room from the LFE track. In this configuration, the REL provides support for both the left and right speakers for two-channel listening, and support for the LFE when movies are playing.
edit:
wat je dus niet kan is je rears en center tonen laten weergeven onder de 100hz tenzij ze op large staan (marantz kan je instelen op 80-100-120hz meen ik, yamaha weet ik niet)
[ Voor 21% gewijzigd door jpvk007 op 05-08-2004 14:20 ]