Op donderdag 29 november 2001 18:30 schreef mathijz het volgende:
[..]
Mijn beeld springt ook op 50Hz als ik de tv-out aansluit. ik dacht dat dit normaal was. Wil je me dus aub op de hoogte houden van je reactie uit taiwan? Tnx.
Wat is een BNC kabel? Is dat die andere poort die op de kaart zit?
Net heb ik dus een mailtje van club3d (powercolor) uit taiwan gehd. Ze zeggen het volgende:
for r7500 vga card and most of other vga card with tv-output , if the vga card have detect the TV-set , the refresh rate will
change 50 or 60Hz to make sure both vga and TV could showup the BIOS setup screen . same status will happen on rage128 pro w/TV &
kyro1/kyro2 .
and when you install the vga driver and restart the windows, you could change the VGA refresh rate to different ( higher ) value by
setting change of in the driver section .
and you could not install the ATi original driver (from the ATi's CD or download from the ATi website ) , this will happen because
the the driver install program will stop install if the vga card is not made by ATi , and the ATi's people said the driver for other
vga productor will put on the web from 01/01/2002 .
Dus...monitor pas aan als windows gestart is of de tvkabel eruit tot windows gestart is...
De drivers updaten kan je overigens wel altijd handmatig doen, anders wacht je eeuwig tot die drivers er komen die wel werken...
Een bnc kabel is een kabel met aan de ene zijde een gewone d-sub15 pins aansluiting (vga dus) en aan de andere kant 5 keer een coax aansluiting, iedere kleur 1 maal (rood/groen/blauw) en hsync en vsync signalen voor de timing. Je monitor moet dit dus wel ondersteunen, dat zie je aan de monitor als je 5 van die coax aansluitpunten als bij een netwerkkaart aan de achterkant hebt. Omdat iedere kleur een eigen kabel heeft storen de signalen elkaar minder bij hoge resoluties.