Chaintech Apogee 9PJL [Ervaringen]

[sailor_ej]

Ik heb dit topic gemaakt omdat der nog geen centraal topic over was.
Post hier al u vragen over het Chaintech Appogee 9PJL mobo.


De Manual

Bios Updates
Versie 1.0
versie 2.0

Plaatjes van het MoBo



Specs

Form Factor	ATX (305mm x 244mm)
CPU	Supports Intel Socket 478 CPU with Hyper-Threading Technology Supports Intel Pentium4/Celeron system bus at 400/533/800MHz
Chipset	Intel 865PE + ICH5, supports Hyper-Threading Technology
Main Memory	Four 184-pin DDR DIMMs up to 4GB Supports Dual-Channel DDR266/333/400 memory
Expansion Slots	One 1.5V AGP slot for 8X/4X AGP Five 32-Bit PCI slots (v2.2 compliant)
Audio Subsystem	Full-duplex operation for simultaneous recording and playback 6 channel speaker audio supports Embedded 32OHM 5w earphone amplifier Supports MIDI and Game port 32 Voice HRTF 3D positional audio, CRL 3D supports MS Direct Sound3D, Aureal A3D and Creative EAX APIs
Video Subsystem	Video 4X/8X AGP
UltraDMA IDE Ports	Supports PIO Mode 4 up to 16.6 Mbps, Multi-Word DMA Mode 2 and Ultra DMA mode 5 up to 100MB/s with Bus Mastering Bus-Mastering software drivers for all common multitasking operating systems
Embedded USB Controller	Three EHCI USB 2.0 Controllers support total 8 USB 2.0/1.1 Ports Support USB 2.0 High-Speed Device @480 Mb/s Transfer Rates Optional USB adapters for additional USB2.0/1.1 ports
On Board Super I/O Controller	ITE 8712 LPC I/O with system monitors hardware Two UARTs support serial ports and IR function (up to 115.2Kbps) for HPSIR and ASKIR One SPP/ECP/EPP parallel port One floppy disk drive connector supports up to 2.88MB
Embedded system monitoring	8 external voltage inputs 2 temperatures sensing for CPU and system 3 Fan speed (CPU, System and Case) monitoring
Boot-Block Flash ROM	Award system BIOS support PnP, APM, DMI, ACPI, & Multi-device booting features
Software	Driver CD (Chipset Autodetect) Value Pack 2003 APOGEE Overclocking
Other Feature	Back panel I/O connector One PS/2 mini-DIN mouse and keyboard ports Four USB Ports and one RJ45 connector Two 9-pin D-SUB male Serial ports One 25-pin D-SUB female Parallel port Audio Line-in, Line-out and Mic-in jacks On-board SATA Controller Build-in ICH5 supports 2 Serial ATA devices for the highest data transfer rates (1.5Gbps burst) On-board VIA VT6306 IEEE1394 Host Controller Serial bus data rates of 100, 200 and 400Mbps IEEE P1394a compliant and IEEE 1394 Programmable ATA/ATAPI interface supporting PIO modes 0-4, DMA modes 0-2 and Ultra DMA modes 0-4 On board connector for external device Three 3x1 pin fan connectors 2x1 pin fan connector with housing for Northbridge Two 5x2 pin USB connectors for additional 4 USB2.0 ports on CBOX2 6x1 pin Infrared connector 3x1 pin wake on LAN connector with housing 3x1 pin wake on Modem connector with housing Two 4x1 pin CD-in connectors with 2.54mm pitch housing 4x1 pin Aux-in connector with 2mm pitch housing 4x2 pin Sub-Woofer connector for Surround and Center/Sub-Woofer phone jacks on CMK 9x2 pin front panel connector 5x2 pin front side audio connector for Headphone and Microphone jacks on CBOX2 5x2 pin Segment display connector for 2-digits Debug LED on CBOX2 Three 8x1 pin IEEE1394 connectors with housing for additional IEEE1394 ports (One connector for front IEEE1394 port on CBOX2; two connectors for two IEEE1394 ports on CMK) 8x2 pin connector for D-SUB female Game/MIDI port on CMK 17x2 pin floppy connector

Review
OC tools New Zeeland


Prijs
E & E Internet Solutions Online Shop (€ 156.19)


Mocht ik nog iets vergeten zijn dan hoor ik het wel

[Sluuut]

Ondersteund dit bord geen S-ATA Raid, en dan Raid0 en/of Raid1 ??

Op de site van Chaintech kan ik er ook niets over vinden...