Geen geluid bij capturen

[Gardocki]

Ik capture met deze instellingen in Virtual Dub 1.4.8:

Audio: PCM 44,100 kHz, 16 Bit Mono 86kb/s
Video: Indeo video 5.10 (Quick Compress)
Capture Settings: "Capture Audio" staat aan
Line In staat niet gemute.

Rara, hoe kan dit? Het is niet echt leuk om tv-programma's op te nemen zonder geluid

[Gardocki]

Ik ben ten einde raad!

[Vae Victis]

Van de Virtual dub website

I get no sound.
First, check that you aren't missing the pass-through. Most video capture cards don't have on-board sound capture and instead use your sound card, so if you don't connect the cable from the capture board to the sound input, you won't get any sound.

Next, bring up Volume Control (sndvol32.exe), go up to the menu and choose Properties, then switch to Recording controls. Make sure Line-in, Aux, or whatever input you are using is selected. Voice chat programs are notorious for automatically switching inputs for you, and some video capture drivers are known to reset volume levels as well.

Finally, if you have a Hauppauge WinTV, check for an AUDIOSEL.EXE application on your hard disk or driver CD. It can be used to force the audio pass-through on for those cards.

Even checken of dit het is ?

[edit]
Heb een beetje de neiging om alle E's te misplaatsen.

[tbusquet]

Heb je niet alleen onder je mixer gekeken onder playback ? Maar ook onder recording ? En staat je line-in dan ge-selecteerd ?

[Verwijderd]

Op zondag 10 februari 2002 12:29 schreef Vae Victis het volgende:

I get no sound.
First, check that you aren't missing the pass-through. Most video capture cards don't have on-board sound capture and instead use your sound card, so if you don't connect the cable from the capture board to the sound input, you won't get any sound.

Next, bring up Volume Control (sndvol32.exe), go up to the menu and choose Properties, then switch to Recording controls. Make sure Line-in, Aux, or whatever input you are using is selected. Voice chat programs are notorious for automatically switching inputs for you, and some video capture drivers are known to reset volume levels as well.

Finally, if you have a Hauppauge WinTV, check for an AUDIOSEL.EXE application on your hard disk or driver CD. It can be used to force the audio pass-through on for those cards.



Even checken of dit het is ?

[edit]
Heb een beetje de neiging om alle E's te misplaatsen.

Met deze vraag zat ik ook net dus ik kan weer verder proberen met wintv