[FreeSCO] Routeren werkt niet.

Pagina: 1
Acties:

  • DGTL_Magician
  • Registratie: Februari 2001
  • Laatst online: 14-06 14:36

DGTL_Magician

Kijkt regelmatig vooruit

Topicstarter
Ik heb een testomgeving met een routertje gebouwd met FreeSCO. Ik heb dit daarna uitgetest met een switch. Later toen ik de router ging inzetten kan hij wel pingen naar het ene adres, maar niet naar het andere. Als ik de adressen omwissel (via setup) en de kabels omwissel, dan kan hij het andere adres wel pingen, maar het eerste weer niet. Wat ik wil is het volgende: het netwerk 10.28 moet gerouteerd worden naar het 10.22 netwerk. (subnet 255.255.0.0)
Ik heb de netwerkkaarten vervangen, de kabels vervangen, en ik weet het nu echt niet meer.
Wie kan mij helpen?

Blog | aaZoo - (Wireless) Networking, Security, DDoS Mitigatie, Virtualisatie en Storage


  • DGTL_Magician
  • Registratie: Februari 2001
  • Laatst online: 14-06 14:36

DGTL_Magician

Kijkt regelmatig vooruit

Topicstarter
Hier nog wat settings uit de webbased interface.

==================================================
== (((((((((((((((((((0000000)))))))))))))))))) ==
==================================================
----- : Interfaces : ---------- ifconfig -----
lo Link encap:Local Loopback
inet addr:127.0.0.1 Bcast:127.255.255.255 Mask:255.0.0.0
UP BROADCAST LOOPBACK RUNNING MTU:3584 Metric:1
RX packets:64 errors:0 dropped:0 overruns:0
TX packets:64 errors:0 dropped:0 overruns:0
eth0 Link encap:10Mbps Ethernet HWaddr 00:60:08:0F:25:26
inet addr:10.22.1.1 Bcast:10.22.255.255 Mask:255.255.0.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:103 errors:6 dropped:0 overruns:0
TX packets:81 errors:0 dropped:0 overruns:0
Interrupt:11 Base address:0x6000
eth1 Link encap:10Mbps Ethernet HWaddr 00:04:76:9B:A1:20
inet addr:10.28.1.1 Bcast:10.28.255.255 Mask:255.255.0.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:15 errors:0 dropped:0 overruns:0
TX packets:4 errors:0 dropped:0 overruns:0
Interrupt:11 Base address:0x6100 ----- : Routing : -----
----- route -n -----Kernel routing table
Destination Gateway Genmask Flags MSS Window Use Iface
255.255.255.255 * 255.255.255.255 UH 1500 0 0 eth1
255.255.255.255 * 255.255.255.255 UH 1500 0 0 eth0
10.22.0.0 * 255.255.0.0 U 1500 0 1 eth0
10.28.0.0 * 255.255.0.0 U 1500 0 1 eth1
127.0.0.0 * 255.0.0.0 U 3584 0 2 lo
default * * U 1500 0 0 eth0
----- : Bridging : ---------- brcfg -----
bridging is DISABLED debugging is DISABLEDbridge id0x0001 00:60:08:0f:25:26
designated root0x0001 00:60:08:0f:25:26bridge max age20max age20
bridge hello time2hello time2bridge forward delay15forward delay15
root path cost0root port0flagsNONE--- port stats ---
port 1port id 0x0001port stateFORWARDING (0x3)
designated root0x0001 00:60:08:0f:25:26
designated bridge0x0001 00:60:08:0f:25:26path cost100designated cost0
designated port1flagsNONEport 2port id 0x0002port stateFORWARDING (0x3)
designated root0x0001 00:60:08:0f:25:26
designated bridge0x0001 00:60:08:0f:25:26path cost100designated cost0
designated port128flagsNONE----- : Port forwarding : -----
----- ipportfw -L -----
Prot Local Addr/Port > Remote Addr/Port
----- : Firewall/Input : ---------- ipfwadm -I -ln -----
IP firewall input rules, default policy: reject
type prot source destination ports
acc all 0.0.0.0/0 0.0.0.0/0 n/a
acc all 0.0.0.0/0 0.0.0.0/0 n/a
acc all 0.0.0.0/0 0.0.0.0/0 n/a
acc all 0.0.0.0/0 255.255.255.255 n/a
acc all 10.28.0.0/16 0.0.0.0/0 n/a
acc all 10.28.0.0/16 0.0.0.0/0 n/a
rej all 10.28.0.0/16 0.0.0.0/0 n/a
rej udp 0.0.0.0/0 0.0.0.0/0 * -> 67:68
rej udp 0.0.0.0/0 0.0.0.0/0 * -> 514
rej all 0.0.0.0/0 10.28.0.0/16 n/a
rej all 10.28.0.0/16 0.0.0.0/0 n/a
rej all 0.0.0.0/0 192.168.168.2 n/a
rej all 192.168.168.2 0.0.0.0/0 n/a
rej all 0.0.0.0/0 192.168.168.3 n/a
rej all 192.168.168.3 0.0.0.0/0 n/a
acc all 0.0.0.0/0 0.0.0.0/0 n/a
----- : Firewall/Forward : ---------- ipfwadm -F -ln -----
IP firewall forward rules, default policy: reject
type prot source destination ports
acc all 10.28.0.0/16 192.168.168.2 n/a
acc all 192.168.168.2 10.28.0.0/16 n/a
acc all 10.28.0.0/16 192.168.168.3 n/a
acc all 192.168.168.3 10.28.0.0/16 n/a
acc all 192.168.168.2 192.168.168.3 n/a
acc all 192.168.168.3 192.168.168.2 n/a
acc/m all 10.28.0.0/16 0.0.0.0/0 n/a
acc/m all 192.168.168.2 0.0.0.0/0 n/a
acc/m all 192.168.168.3 0.0.0.0/0 n/a
acc/m all 0.0.0.0/0 0.0.0.0/0 n/a
acc/m all 0.0.0.0/0 0.0.0.0/0 n/a
acc/m all 10.28.0.0/16 0.0.0.0/0 n/a
----- : Firewall/Active Masquerading entries : ---------- ipfwadm -M -ln -----
IP masquerading entries----- : IP leases : -----
----- cat /etc/dhcpd.leases -----

Blog | aaZoo - (Wireless) Networking, Security, DDoS Mitigatie, Virtualisatie en Storage


  • DGTL_Magician
  • Registratie: Februari 2001
  • Laatst online: 14-06 14:36

DGTL_Magician

Kijkt regelmatig vooruit

Topicstarter
Niemand?

Blog | aaZoo - (Wireless) Networking, Security, DDoS Mitigatie, Virtualisatie en Storage


Verwijderd

Niets mis met een van de verbindingskabels toevallig?

  • Kirpeknots
  • Registratie: Mei 2001
  • Laatst online: 07-08 23:39

Kirpeknots

Wazzup!

keuze 21 in het setup menu.

Absolutely trust local nets op Y of P zetten.