lap tekst maar dit kreeg ik terug van creative. Ik had het voor een vriend gevraagd en die heeft het met 1 van deze dingen opgelost, ik zal nog even navragen welke
Also, try the following steps and see if you can fix the problem:
There are numerous causes of and possible solutions to problems with bus noise
with PCI soundcards. This can sound like scratching/hissing/crackling/popping
and may sometimes get worse when eg. moving the mouse. Here are some possible
solutions.
* Update the PC's BIOS.
* Enable "Enhanced Chip Performance" in the BIOS. This may not be present on all
machines.
* In Device Manager, disable DMA for IDE Hard Disks and CD/DVD Drives - this is
not relevant if they are SCSI drives. Unfortunately, this may also result in a
performance decrease. To avoid this, the latest IDE Bus Master drivers should be
installed for the system and DMA enabled. Here ar
e the links to driver download pages of the majopr chipset manufacturers:
VIA/ETEQ:
http://www.via.com.tw/drivers/index_new2.htm
AMD: http://http://www.amd.com/products/cpg/bin/
Intel:
http://support.intel.com/support/chipsets/driver.htm
SIS:
http://www.sis.com.tw/support/download/driver.htm
Please note that after installing any IDE driver other than that included with
the operating system, DMA should no longer be enabled/disabled through Device
Manager. Instead it will be possible either during the driver installation or
with a utility provided with the IDE drivers.
* In the BIOS, ensure that DMA mode for IDE devices is not enabled but instead
set to AUTO.
* Try moving the soundcard to different PCI slots - the farther away from
components like the Hard-Drive and Processor, the better.
* In the BIOS, try changing the latency value of the PCI-Bridge or PCI Latency
to 0 - the default is 32. This helps in some cases and shouldn't have any
negative impact on other hardware. For more d
etailed information on this and ways to change this value if not present in your
BIOS, please check here:
http://www.deinmeister.de/mvp3_zlt_e.htm
* If there is a "Memory Hole" setting in the BIOS, try changing this from
"disabled" to "15M-16M".
* If there is a PCI Graphic Card installed, ensure that both this and the
soundcard are not sharing the same IRQ and try lowering the Hardware
Acceleration of the Graphic Card. Also contact the Graphic Card manufacturer to
see if there is a way to disable "PCI-retries" or similar. If the system has an
AGP slot, it may be necessary to use an AGP graphic card instead of PCI.
See if that helps.