Kan een Alpha 8045 heatsink op een Asus A7V266? Het kan wel, maar je moet wel even buigen, vijlen of dremelen!
Hier even het officiele antwoord van Alphanovatech, voor de geinteresseerden:
Hier even het officiele antwoord van Alphanovatech, voor de geinteresseerden:
Thank you for your interest in our products.
We have received many inquires regarding this board. There
is one capacitor, close to the USB connector, that will contact
the heat sink. I have had a few people tell me that they mounted
it by bending over the capacitor. I can't recommend this, as it may
damage your board. However, others either filed or dremeled the corner
to provide clearance, according to them, it did not take much.
The decision would be up to you, but due to the issues I discussed,
we have listed the board as incompatible.
http://www.micforg.co.jp/mb_inf_pal8045e.html
For use on an XP chip, we recommend the use of one
additional wahser/spring, as the XP is a little thinner than
the Tbird. I have hear that Pabst and Panaflow fans provide
good performance at quiet noise levels.
I hope I have answered your questions.
Sincerely,
Glenn Summerfield
glenn@alphanovatech.com