The WAIT is typically for three hours or more, after which time you will be allowed another three attempts. You need to leave the power on during this waiting period.
Lees ook dat je de tv 8 uur onder stroom moet houden voordat je naar dat 5 cijferige invoerveld kan. lijkt me sterk maar is het proberen waard.
Misschien kan je hier wat mee mocht je mastercode niet werken.
Service code
The service code
- unlocks the product, but does not affect the pin-code setting
- gives you 12 hours service time
Entering the Service code
1. When the product asks for PIN-CODE press and hold (left arrow) for 3 seconds.
2. The Master code menu appears.
3. Enter the Service code: 1 1 1 1 1.
Important notice concerning Service time
The service time is active as long as the product is connected to the mains, including
Standby.
To obtain maximum service time:
Only connect the product to the mains while you are performing actual service on
the product.
When the service time is expired, the product can only be unlocked by entering
the PIN-code or the Master code.
If the PIN-code has been forgotten the only way to unlock the TV again is by
entering a 5 digit Master-code.
The Master-code is ordered by sending a request either via the Retail System or on
the Master-code formula. If non of these options are available please contact Bang &
Olufsen.
When the TV prompts for a PIN-code, press and hold (left arrow) down to bring up the
MASTERCODE menu.
Enter the Master-code and press GO. This will deactivate the PIN-code and
reactivate the TV.
The TV is locked by PIN-code when:
- The PIN-code is activated and the mains is disconnected for more than 15- 30
minutes.
The TV is unlocked when the PIN-code is entered.
The PIN-code counter is set to 5 attempts within 3 hours.
When a wrong PIN-code has been entered 5 times within 3 hours, the television
cannot receive any commands for a period of 3 hours.
After this period the PIN-code counter is reset.
The TV must be in standby mode to activate the timer.
Dus wat ik ervan begrijp moet je die pijl pas indrukken als je in het pincode scherm zit.
[
Voor 94% gewijzigd door
Toerq op 23-12-2022 19:34
]