Partinfo geeft deze foutmeldingen. - Opslag en back-up

zaterdag 11 augustus 2001 10:43

Acties:

Topicstarter

Partinfo geeft over al me schijven foutmeldingen zag ik net, me grootste 60gb schijf is nu ook gecrashed, en de rest ziet er ook niet goed uit zie ik nu! :

Info: Begin C,H,S values were large drive placeholders.
Info: End C,H,S values were large drive placeholders.
Actual values are:
0 1 00 256 0 1 0F 2494 254 63 4112640 35969535

Info: End C,H,S values were large drive placeholders.
Actual values are:
4112640 1 00 1022 0 1 05 1787 254 63 16418430 12305790

Info: End C,H,S values were large drive placeholders.
Actual values are:
16418430 0 00 1022 1 1 0B 1787 254 63 16418493 12305727

Info: End C,H,S values were large drive placeholders.
Actual values are:
16418430 0 00 1022 1 1 0B 1787 254 63 16418493 12305727

Info: Begin C,H,S values were large drive placeholders.
Info: End C,H,S values were large drive placeholders.
Actual values are:
16418430 1 00 1788 0 1 05 2494 254 63 28724220 11357955

Info: Begin C,H,S values were large drive placeholders.
Info: End C,H,S values were large drive placeholders.
Actual values are:
0 1 00 384 0 1 0F 5004 254 63 6168960 74236365

Info: Begin C,H,S values were large drive placeholders.
Info: End C,H,S values were large drive placeholders.
Actual values are:
16128 0 74 116054 67 35 6E 221944 121 3818644117651701126256
Warning: Partition boot flag expected to be 0x00 or 0x80,
not 0x74. This should not be a problem.
Error #107: Partition begins after end of disk.
ucBeginCylinder (116054) must be less than 7473.
Info: Partition didn't begin on head boundary.
ucBeginHead expected to be 0 or 1, not 67.
Info: Partition didn't begin on head boundary.
ucBeginSector expected to be 1, not 35.
Error #109: Partition ends after end of disk.
ucEndCylinder (221944) must be less than 7473.
Info: Partition didn't end on cylinder boundary.
ucEndHead expected to be 254, not 121.
Info: Partition didn't end on cylinder boundary.
ucEndSector expected to be 63, not 38.

Die laatste zie je meerdere keren, en is ECHT niet gezond, dat is ook op de schijf die een fout heeft.

De foutcode is 108, wat betekent :

Error 108 Partition doesn't end at end of cylinder

Dat is niet al te best, enige wat ze me bij powerquest aanraden is de technical support eens te bellen en uit te leggen, sure.

Maar hoe kan het bij al mijn schijven zijn?

PS:

handige links