Matrox Marvel G400/TV kabeltje?

Pagina: 1
Acties:

  • OzBoz
  • Registratie: Maart 2000
  • Laatst online: 17-08 13:58

OzBoz

.:.H.:.I.:.P.:.

Topicstarter
Heb geprobeerd de forumpjes af te zoeken maar zonder succes, hierbij mijn bescheiden vraagje Afbeeldingslocatie: http://tweakers.net/g/forum/g/smilies/smile.gif

Weet iemand of je een kabel kan kopen voor deze kaart zodat je ipv de Break-Out-Box gewoon een tweede monitor kan aansluiten? Tweede aanluiting is namelijk een beetje afwijkend en vroeg me af of er adresjes waren voor een kant-en-klaar kabeltje, lijkt me nl prettig. TV als tweede monitor is bij paketten als Dreamweaver en Pshop niet echt geschikt.

Thankz voor replyen..

My Fizion | My 3D prints | LinkedIn


Verwijderd

Effe de review van de G400-TV opgezocht op matroxusers.com Helaas is er geen kabel verkrijbaar voor 2e monitor.

Quote uit te review;
"The backplate holds two connectors but these are not the same two RGB connectors as found on the other G400s, the second is for attaching the BOB cable to. What this means is that while supporting DualHead the Marvel G400-TV only does it via an a TV attached to the BOB, there is no secondary RGB connector. This I found a disappointment for me personally as I have been spoilt and simply cannot live without running dual RGB monitors with my desktop spread across and no matter how good your TV it just isn't up to the job of running a high resolution Windows desktop."

  • tazzman
  • Registratie: Juli 2000
  • Laatst online: 05-01 10:48

tazzman

a real boardmonkey

Hebben ze nu ook al zoiets als een G400 TV? Terug brengen en direct een DualHead halen :)

Het nieuwe speelgoed: een Saab 9-3 Aero (absoluut, helemaal en compleet fantastisch....)