Je moet er vanuit gaan dat elke connectie overgang of dit nu een patchkabel, RJ-connector, las of wat dan ook is; verlies geeft en gevoelig is voor storingen en interferentie.
Je wil dus zo min mogelijk overgangen hebben van begin tot eindpunt.
Ook wil je zo lang mogelijk je twisten blijven behouden in de aderparen. Dit is bedoelt om interferentie tegen te gaan. Je moet je twist dan ook tot aan je connectie in je paneel door laten lopen.
Wat betreft de CAT5e specificatie (volgens mij is het geen officiële standaard ??).
Category 5e (CAT5e) cable, also known as Enhanced Category 5, is designed to support full-duplex Fast Ethernet operation and Gigabit Ethernet. The main differences between CAT5 and CAT5e can be found in the specifications. The performance requirements have been raised slightly in the new standard.
CAT5e has stricter specifications for Power Sum Equal-Level Far-End Crosstalk (PS-ELFEXT), Near-End Crosstalk (NEXT), Attenuation, and Return Loss (RL) than those for CAT5. Like CAT5, CAT5e is a 100-MHz standard, but it has the capacity to handle bandwidth superior to that of CAT5.
M.a.w. Cat5e support 'officieel' 1 Gbit verbindingen. Verder is de kabel van Cat5e van betere specificatie dan die van Cat5.
The best thing about UDP jokes is that I don't care if you get them or not.