Heb een nieuwe installatie gedaan van een Asus A3FP-5011P notebook.
Op de asus website heb ik alle drivers gedownload, maar als ik bij mijn windows XP kijk bij apparaatbeheer zie ik dat er 2 dingen niet geinstalleerd zijn.
Dat is de :
Base System-apparaat
USB 2.0
Er zit SP2 op.
Nu heb ik gegoogled en gezocht maar krijg de drivers niet gevonden.
Wie kan mij daarmee helpen.
Alvast heel erg bedankt.
Met PCI32 krijg ik de volgende gegevens:
------------------------------------------------------------------------------------------------
Bus 0 (PCI Express), Device Number 29, Device Function 7
Vendor 8086h Intel Corporation
Device 27CCh 82801G (ICH7 Family) USB 2.0 Enhanced Host Controller
Command 0006h (Memory Access, BusMaster)
Status 0290h (Has Capabilities List, Supports Back-To-Back Trans., Medium Timin
g)
Revision 02h, Header Type 00h, Bus Latency Timer 00h
Self test 00h (Self test not supported)
PCI Class Serial, type USB 2.0 (EHCI)
Subsystem ID 12C71043h Unknown
Subsystem Vendor 1043h ASUSTeK Computer Inc
Address 0 is a Memory Address (anywhere in 0-4Gb) : FEB3BC00h
System IRQ 23, INT# A
New Capabilities List Present:
Power Management Capability, Version 1.1
Does not support low power State D1 or D2
Supports PME# signalling from mode(s) D0, D3hot, D3cold
PME# signalling is currently disabled
Current Power State : D0 (Device operational, no power saving)
3.3v AUX Current required : 375mA
USB 2.0 EHCI Debug Port Capability
IRQ control is currently managed by the system APIC controller - IRQ info is
not actual hardware settings...
------------------------------------------------------------------------------------------------
Op de asus website heb ik alle drivers gedownload, maar als ik bij mijn windows XP kijk bij apparaatbeheer zie ik dat er 2 dingen niet geinstalleerd zijn.
Dat is de :
Base System-apparaat
USB 2.0
Er zit SP2 op.
Nu heb ik gegoogled en gezocht maar krijg de drivers niet gevonden.
Wie kan mij daarmee helpen.
Alvast heel erg bedankt.
Met PCI32 krijg ik de volgende gegevens:
------------------------------------------------------------------------------------------------
Bus 0 (PCI Express), Device Number 29, Device Function 7
Vendor 8086h Intel Corporation
Device 27CCh 82801G (ICH7 Family) USB 2.0 Enhanced Host Controller
Command 0006h (Memory Access, BusMaster)
Status 0290h (Has Capabilities List, Supports Back-To-Back Trans., Medium Timin
g)
Revision 02h, Header Type 00h, Bus Latency Timer 00h
Self test 00h (Self test not supported)
PCI Class Serial, type USB 2.0 (EHCI)
Subsystem ID 12C71043h Unknown
Subsystem Vendor 1043h ASUSTeK Computer Inc
Address 0 is a Memory Address (anywhere in 0-4Gb) : FEB3BC00h
System IRQ 23, INT# A
New Capabilities List Present:
Power Management Capability, Version 1.1
Does not support low power State D1 or D2
Supports PME# signalling from mode(s) D0, D3hot, D3cold
PME# signalling is currently disabled
Current Power State : D0 (Device operational, no power saving)
3.3v AUX Current required : 375mA
USB 2.0 EHCI Debug Port Capability
IRQ control is currently managed by the system APIC controller - IRQ info is
not actual hardware settings...
------------------------------------------------------------------------------------------------