[Cisco2950] Reset to factory defaults

[DaSquad117]

Ik heb hier een Cisco 2950 gekregen. Nu weet ik daar niks van paswoord van, dus wil ik hem resetten.

Dus ik steek de power cabel in en blijf op 't mode knopje drukken, zodat ik kan wijzigingen aanbrengen in 't flash filesystem. Ik wil de configuratie wissen. Maar ik krijg 't volgende:

C2950 Boot Loader (C2950-HBOOT-M) Version 12.1(11r)EA1, RELEASE SOFTWARE (fc1) Compiled Mon 22-Jul-02 17:18 by antonino WS-C2950-24 starting... Base ethernet MAC Address: 00:14:a9:fd:de:40 Xmodem file system is available. The system has been interrupted prior to initializing the flash filesystem. The following commands will initialize the flash filesystem, and finish loading the operating system software: flash_init load_helper boot switch: flash_init Initializing Flash... flashfs[0]: 359 files, 4 directories flashfs[0]: 0 orphaned files, 0 orphaned directories flashfs[0]: Total bytes: 7741440 flashfs[0]: Bytes used: 4674560 flashfs[0]: Bytes available: 3066880 flashfs[0]: flashfs fsck took 7 seconds. ...done initializing flash. Boot Sector Filesystem (bs:) installed, fsid: 3 Parameter Block Filesystem (pb:) installed, fsid: 4 switch: load_helper switch: dir flash unable to stat flash/: permission denied switch:

Ik heb dus geen toegang tot de flash
Kan ik op één of andere manier er toch toegang tot krijgen?

[Bl@ckbird]

Zie:
http://www.cisco.com/en/U...186a008007e83c.html#13149

Getting "Permission Denied" error message during the bootup.

This error message appears when the boot parameters are not set correctly. In most of the cases, when setting the boot parameters during or after the upgrade, the word flash: is mistyped or completely missed.

Go to Setting BOOT Parameters at ROMMON (Switch: Prompt) to verify and set the BOOT parameters correctly.

If setting the BOOT parameters to the correct filename does not resolve the issue, perform an X-Modem upgrade, as the file present on the Flash memory could be corrupted or invalid.

Voor een X-Modem recovery, zie:
http://www.cisco.com/en/U...6a0080169696.shtml#topic2
(Step 4)

[DaSquad117]

Thanx!. Inderdaad een verkeerd commando, 't moest flash: zijn.